Tuesday, 21 January 2014

If One Needs To Do Powder Coating Hickory NC Deserves To Be Considered First

By Judy Sullivan


When in need for perfectly applied powder coating Hickory NC is the correct place to give priority consideration. Powder coating refers to the activity of covering an object or surface with free-flowing dry powder. The method has been verified to be better and superior to conventional liquid powders due to the many benefits that accompany it. One of the main differences between the 2 kinds of coatings is that conventional liquid paints require a solvent whereas dry powders do not.

When painting a surface or an article using this process, there are three fundamental steps that ought to be followed in the precise sequence they come. First step entails preparing surfaces to be coated prior to the actual painting. The next procedure is the actual painting and then thirdly the curing process. All steps are important for perfect results to be achieved.

Before even beginning the preparation of a surface to be coated, one should consider materials the surface is composed of. The materials should determine the type of powder to be selected for the finish. Coating process is performed using two types of polymers, that is, thermoplastic and thermoset. These polymers are meant to bond with various metal types to produce best results. A coat that does well on a car may not do as fine on a small house decoration.

The coat sprinkled on an object adheres on every section of the object. This implies that it may seal off clamps, bearings, bolts and nuts and any other surface that might have to be opened sometimes later. There is therefore necessity for thorough cleaning of a surface before applying paint. Foreign materials, rust scale, dirt, and mill must be eliminated using appropriate cleaning techniques.

Hard metals such as steel and cast iron can be cleaned using abrasive or bead blasting. Light sanding, grease, oil, paint, and other chemicals can be removed from surfaces using chemical solvent cleaning. Chemical solvent cleaning should be used for finishing the preparation process. Soft alloy metals such as magnesium and aluminium can be removed using solvent cleaning, sanding, and wire brushing. Sand paper can also be used on some other kinds of contaminants.

The actual coating exercise is performed using guns or compressed air sprayers. The guns or compressed air electro-statically charges the dry powder particles to make them adhere onto the surfaces being painted. The surfaces are usually grounded for particle bonding to take place. Guns appear in diverse makes and could be bought from any store for as low as a hundred US Dollars.

The curing must be done relying on the type of metal under consideration. If the item is small enough, a traditional kitchen oven can work just well otherwise infrared heat lanterns or other flame-less heat sources could be utilized. Application of the dry coat on already heated substrates is also a choice that most individuals are settling for nowadays. Curing should take about ten to fifteen minutes.

When in necessity for well performed powder coating Hickory NC offers a good location to consider giving a visit. There are several firms in the region that render these services at considerably affordable rates. They can be contacted any time for the services. Internet can offer a few contacts to call.




About the Author:



No comments:

Post a Comment